Testing & Training
| New Products |
to see our new
1.2 million lb.
G-2150 Crosby® Bolt Type Chain Shackles
Item # 1019772
Item # 1019772, G-2150 Crosby® Bolt Type Chain Shackles
Email This Page
Save To Favorites
Working Load Limit permanently shown on every shackle
Forged-Quenched and Tempered with alloy pins
Capacities 1/3 thru 150 metric tons
Look for the Red Pin® the mark of genuine Crosby quality
Shackles 55 metric tons and smaller can be furnished proof tested with certificates to designated standards, such as ABS, DNV, Lloyds or other certification. Charges for proof testing and certification available when requested at the time of order
Shackles 85 metric tons and larger can be provided as follows:
- Non-Destructive Tested
- Serialized Pin and Bow
- Material Certification (Chemical) Certification must be requested at time of order
Hot Dip Galvanized or Self-Colored
Bolt type anchor shackles within head bolt-nut with cotter pin. Meets the performance requirements of Federal Specification RR-C-271D Type IVB, Grade A, Class 3, except for those provisions required of the contractor.
The Crosby® Group, Inc.
Hot Dipped Galvanized
Nominal Size (inches)
Working Load Limit (Ton)
Weight each (lbs)
Tolerance for Dimension G
Tolerance for Dimension A
RR-C-271D Type IVB, Grade A, Class 3
Maximum Proof Load is 2.0 times the Working Load Limit. Minimum Ultimate Strength is 6 times the Working Load Limit
Read this before using shackles
G-213 and G-215 Shackles are also called Round Pin Shackles. Round pin shackles are used for tie down, towing, suspension or lifting applications where the load is strictly applied in-line.
G-209 and G-210 Shackles are also called Screw Pin Shackles or Screw Pin Anchor Shackles. Screw Pin Shackles can be used in any application where a round pin shackle is used. In addition, screw pin shackles can be used in applications involving side-loading circumstances. Reduced working load limits are required for side loading applications. While in service, do not allow the screw pin to be rotated by a live line, such as a choker application.
G-2130, G-2150 and G-2140 Shackles are also called Bolt-Type Shackles or Safety Anchor Shackles. These types of shackles have a bolt, nut and cotter-type pin to secure the nut. Bolt-Type Shackles can be used in any application where round pins or screw pin shackles are used. In addition, they are recommended for permanent or long-term installations and where the load may slide on the shackle pin causing the pin to rotate.
Wire Rope Slings
Wire Rope Slings
The Carpenter Group
| 222 Napoleon St. | San Francisco, CA 94124 | Toll-Free:
| Ph: 415.285.1954 | Fx: 415.285.0176 | www.thecarpentergroup.com
Site created by
ThomasNet Web Solutions